Caution – If the gap the server must cross is wider than 2 inches (51 mm), or has an
elevation of greater than 1 inch (25.4 mm), consult with you facilities manager to
design and use a metal plate that will bridge the gap while supporting the full
weight of the server.
●
Use a 3/16-inch (4.6-mm) thick A36 metal plate with beveled edges when
crossing gaps in the floor.
Related Information
"Physical Dimensions" on page 24
■
"Access Route Guidelines" on page 55
■
"Move the Server to the Installation Site" on page 79
■
Installing the Server
83