Table of Contents
Advertisement
Type
Network addresses
SPs
Oracle VM Server for
SPARC logical domains
Related Information
"Connecting the Front SP Cables" on page 97
■
"Connecting the Rear Power Cords and Data Cables" on page 119
■
"Powering On the Server for the First Time" on page 141
■
SP Cables
The server contains two dual-redundant SPs (SP0 and SP1) on the front of the server.
One of the SPs functions as the Active SP to manage the server, and the other one
acts as a Standby SP that will assume the Active SP role in the event of an SP failure.
Note – Either SP (SP0 or SP1) can take the Active SP role. Do not assume that SP0
will take the Active SP role and that SP1 will take the Standby SP role.
60
SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
Description
At least one network cable and network
address for each PDomain.
(Optional) Network cables and
addresses for each installed network
interface PCIe card.
Required cables:
• Two CAT5, or better, serial cables
• Two CAT6, or better, network cables
Required network addresses:
• Three network addresses
• One network address per PDomain
At least one network address for each
logical domain.
Link
"PDomain Cables and Network
Addresses" on page 65
"PCIe Network Interface Cards" on
page 65
"SP Cables" on page 60
"SP Network Addresses" on page 64
"Oracle VM Server for SPARC Network
Addresses" on page 66
Advertisement
Table of Contents
Need help?
Do you have a question about the sparc M5-32 and is the answer not in the manual?
Questions and answers