Oracle Solaris Os Configuration Parameters - Oracle sparc M5-32 Installation Manual

Oracle Solaris OS Configuration
Parameters
When configuring the Oracle Solaris OS, you will be prompted for the following
configuration parameters. For more information about these settings, refer to the
Oracle Solaris documentation.
Parameter
Language
Locale
Terminal Type
Network?
Multiple Network Interfaces
DHCP?
Host Name
IP Address
Subnet?
Subnet Netmask
IPv6?
Security Policy
Confirm
Name Service
NFSv4 Domain Name
Time Zone (Continent)
Time Zone (Country or Region)
156 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
Description
Select a number from the displayed languages list.
Select a number from the displayed locale list.
Select a terminal type that corresponds with your terminal device.
Select Yes.
Select the network interfaces that you plan to configure. If you are not sure,
select the first one in the list.
Select Yes or No according to your network environment.
Type the host name for the server.
Type the IP address for this Ethernet interface.
Select Yes or No according to your network environment.
If your answer to Subnet? was Yes, type the netmask for the subnet for your
network environment.
Specify whether or not to use IPv6. If you are not sure, select No to
configure the Ethernet interface for IPv4.
Select either standard UNIX security (no) or Kerberos Security (Yes). If you
are not sure, select No.
When prompted, review the onscreen information and change it if needed.
Otherwise, continue.
Select the name service according to your network environment.
Note - If you select a name service other than None, you will be prompted
for additional name service configuration information.
Select the type of domain name configuration according to your
environment. If you are not sure, select Use the NFSv4 domain
derived by the system.
Select your continent.
Select your country or region.