Table of Contents
Advertisement
8. Use a tie-wrap to secure the power cord to a support located above the AC input
filter.
Note – Do not overtighten the tie-wraps, and provide some slack in case you need to
detach the power cord or replace the AC input filter. However, do not allow the
power cord to lay on the cable management hooks below the AC input filters. These
hooks cannot support the weight of the power cords.
9. Route the power cord to the right and determine if you will be routing the
cables up through the top of the server or down through the bottom.
If you are routing the power cord upward, thread the power cord out through
■
the top of the server.
If you are routing downward, lead the power cord to the right cable channel.
■
Continue to lead the power cord down the right cable channel and then
through the floor cutout underneath the server.
Connecting the Rear Power Cords and Data Cables
129
Advertisement
Table of Contents
