Oracle sparc M5-32 Installation Manual page 162

5. Verify that you have set the network addresses correctly.
For brevity, this example shows only the output for the IP address property.
-> show /SP/network -level 2 -output table pendingipaddress pendingipnetmask
pendingipgateway
/SP/network -level 2 -output table pendingipaddress pendingipnetmask
pendingipgateway
Target
--------------------+------------------------+------------------
/SP/network/
ACTIVE_SP
/SP/network/HOST0
/SP/network/HOST1
/SP/network/HOST2
/SP/network/HOST3
/SP/network/SP0
/SP/network/SP1
. . . . . . .
->
Note – After setting the IP addresses, you must type the set /SP/network
commitpending=true command at the Oracle ILOM prompt before the new
addresses to take affect.
6. Display the IP addresses to confirm that they have been updated.
-> show /SP/network -level 2 -output table ipaddress ipnetmask ipgateway
7. Continue the installation by specifying the altitude of the server.
See
Related Information
"Planning Network Addresses" on page 59
■
Oracle ILOM documentation
■
152 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
| Property
| pendingipaddress
|
| pendingipaddress
| pendingipaddress
| pendingipaddress
| pendingipaddress
| pendingipaddress
| pendingipaddress
"Set the Altitude of the Server" on page
| Value
| xxx.xxx.xxx.xxx
|
| xxx.xxx.xxx.xxx
| xxx.xxx.xxx.xxx
| xxx.xxx.xxx.xxx
| xxx.xxx.xxx.xxx
| xxx.xxx.xxx.xxx
| xxx.xxx.xxx.xxx
153.
(http://www.oracle.com/goto/ILOM/docs)