Mass Storage Devices - Sun Microsystems SPARCstation 2 Service Manual

Mass Storage Devices

•
GS Graphics Accelerator Board
This option consists of two boards that are plugged to each other on their
component sides. They are triple-wide SBus boards and occupy three SBus
slots. Figure 4-2 shows the top side of GS Graphics Accelerator Board when
it is installed in the system unit. This option provides 24-bit color and 3
dimensional graphics capabilities. It also requires a 76 Hz color monitor.
•
Video Frame Capture Board
This board occupies one SBus slot. This board takes video input and
displays it on color or monochrome monitors.
•
SBus Printer Card
This board occupies one SBus slot. This board connects the system to
printing, plotting and scanning devices.
•
1-Bit Analog Frame Buffer Board
This board occupies one SBus slot. It controls the video output from the
system to a monochrome monitor.
The following is some of the mass storage devices available. Note that the
following list is not necessarily an inclusive list of mass storage devices
available for SPARCstation 2.
•
Hard disk drives
Two optional 3 1/2-inch SCSI 207 MB hard disk drives (see Figure 1-2) can
be installed in the system unit. Chapter 4 describes how to replace the
optional hard disk drives in the system unit.
•
Optional expansion modules. The following are available:
Desktop Storage Packs (DSPs)
Desktop Backup Pack 150 MB SCSI-compatible tape drive only
°
Desktop Disk Pack 207 MB hard disk drive only
°
Desktop SunCD Pack 644 MB (maximum) CD-ROM only
°
External Storage Modules (ESMs)
External Storage Module 327 MB hard disk drive only
°
External Storage Module 327 MB hard disk drive and 150 MB cartridge
°
tape drive
External Storage Module dual 327 MB hard disk drives
°
System Overview
1
15