Parameters For Module To Module Communication (Mtm) - Siemens SIMATIC ET 200SP Manual

Cam control operating mode
6.2 Parameters/address space
Pulsed cam output period
This parameter specifies the period of the pulsed cam output.
Potential group
With the "Potential group" parameter, you specify whether the module is plugged into a light
or dark BaseUnit.
A potential group always begins with an I/O module that is plugged into a light BaseUnit. All
modules inserted to the right of this that are plugged into dark BaseUnits belong to the same
potential group, because the dark BaseUnits are supplied via the light BaseUnits.
The potential group ends at a new light BaseUnit or the end of the station.
See also
Distributed I/O System ET 200SP
(https://support.industry.siemens.com/cs/ww/en/view/58649293)
6.2.3.2

Parameters for module to module communication (MtM)

Slot of encoder module
Specifies the slot of the encoder module for the module to module communication (MtM)
Subslot of encoder module
This value is permanently preset to 1.
Encoder module
Specifies the module that is used as an encoder module for the module to module
communication (MtM)
Note
Parameter assignment of the encoder module
The parameter must be assigned identical with the "Encoder module" parameter under
Parameters in cam control operating mode (Page 74).
78
Digital output module DQ 4x24VDC/2A HS (6ES7132-6BD20-0DA0)
Manual, 06/2018, A5E32855695-AC