Installing The Interface Module - Siemens SIMATIC ET 200MP System Manual

Installation

5.4 Installing the interface module

Uninstalling the power supply module
The power supply module is wired:
1. Turn off the fed supply voltage.
2. Open the front cover.
3. Switch off the power supply module.
4. Loosen the power cable connector and remove it from the power supply module.
5. Undo the power supply module's fixing screw(s).
6. Pivot the power supply module out of the mounting rail.
Reference
Further information can be found in the Product Manuals for the power supply modules.
5.4 Installing the interface module
Introduction
The interface module connects the ET 200MP with the PROFINET-IO and exchanges data
between the higher-level controller and the I/O modules.
Requirements
The mounting rail is installed.
In a power supply module located before the interface module, a U connector is inserted on
the back right.
Tools required
Screwdriver with 4.5 mm blade
46
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01