Using Keys To Move Around In The Programs; Section 9 Programming - NEC univerge sv8100 Installation Manual

UNIVERGE SV8100
U
S 5
SING
ECTION
Once you enter the programming mode, use the keys in the following chart to enter
data, edit data and move around in the menus.
Use this key...
0~9,  and # Enter data into a program.
Complete the programming step you just made. When a program entry displays, press Transfer
Transfer
to bypass the entry without changing it.
Recall Delete the entry to the left.
Exit one step at a time from the program window currently being viewed.
For example, if you're programming item 5 in 15-03, press Answer to enter a new option in
Answer
program 15-03. Press Answer again to select a new program in the 15- series. Press Answer a
third time to enter a new program beginning with 1. Press Answer one last time to bring you to
the beginning program display, allowing you to enter any program number.
To switch extension, line, etc. being programmed press Redial. The cursor moves up to the top
Mic
row of the display. Press Redial again to move the cursor back to the middle row.
Use programmed settings to help with the program entry. These settings vary between programs
from LINE 1 = 0 (off) and LINE 2 = 1 (on) to preset values for timers where LINE 1 = 5, LINE 2 =
10, LINE 3 = 15, etc.
Line Keys For programs with this option, the line key which currently matches the programmed setting is
On steady.
The display may also indicate Softkeys which allow you to select the values as well (-1 and +1
step through these programmed settings.)
Line Key 1 Program a pause in a Speed Dial bin.
Line Key 2 Program a recall/flash in a Speed Dial bin.
Line Key 3 Program @ in a Speed Dial bin.
Scroll backward through a list of entry numbers (e.g., from extension 101 to 102, 103, etc.) or
through entries in a table (e.g., Common Permit Table).

Vol
If you enter data and press this key, the system accepts the data before scrolling forward.
Scroll forward through a list of entry numbers (e.g., from extension 101 to 102, 103, etc.) or
through entries in a table (e.g., Common Permit Table).

Vol
If you enter data and press this key, the system accepts the data before scrolling backward.
ACD Installation Manual
K M A
EYS TO OVE
P
ROUND IN THE ROGRAMS
When you want to. . .
Issue 4.0
4 - 5