Switching The Server On And Off - Fujitsu PRIMERGY BX600 User Manual

Installation and initial operation

Switching the server on and off

If only flickering stripes are displayed on the screen after the server has
!
been switched on, switch off the server immediately. See
02-BX600-67.
The system ON/OFF power button does not disconnect the system from
i
the mains voltage. To completely disconnect it, you must remove the
power plugs from the sockets.
Switching ON the system (system is powered OFF)
Ê Press the system power ON/OFF button for 2 seconds. Depending on the
BIOS settings, the server blades can be switched on automatically one after
another (see BIOS manual) according to the slot numbering (see
02-BX600-5).
Ê If necessary, switch ON the required server blades.
First-time installation
A detailed description can be found on
System already installed
The system is switched ON and the activated server blades perform a
system test and boot the operating system.
Switching OFF the system (system is powered ON)
The system is operating (server blades are also switched ON).
Ê For graceful shutdown of all server blades, press the system power
ON/OFF button for 4 seconds. The server blades will then be powered OFF.
Ê For hard shutdown of all server blades, press the system power ON/OFF
button for 10 seconds. The server blades will be powered OFF immediately.
U41057-J21-Z146-1-76
Initial operation and operating
page 02-BX600-39ff.
March 2006
page
page
02 BX600 37
– –