Replacing The Server Blade Lithium Battery - Fujitsu PRIMERGY BX600 User Manual

The Server Blade
! If only one processor is installed in a server blade, a dummy heat sink
must be installed over the second CPU socket to guarantee the stipu-
lated cooling of the server blade components.

Replacing the Server Blade Lithium Battery

To permanently save system information, a lithium battery is installed on the
server blade to power the CMOS memory. When the battery voltage is too low or
the battery is empty, a corresponding error message is displayed. In this case
the lithium battery must be replaced.
– Incorrect replacement of the lithium battery may lead to risk of
!
explosion. Make sure the plus pole is facing up.
– The lithium battery must be replaced with an identical battery or with
a battery type recommended by the manufacturer (CR2032).
– Do not throw lithium batteries into the trashcan. Please dispose of
batteries in accordance with local government regulations.
Requirements
– The relevant server blade has been removed (see
02 BX600 88
– –
Removal and Installation Routines
March 2006
page 02-BX600-73)
U41057-J21-Z146-1-76