The Management Blade
1
Ê Push the locking spring in the direction of the arrow (1) so that the lithium
battery snaps out of the holder, and pull the battery out (2).
Ê Slide the new battery of identical type into the holder (3), and push it in the
direction of the arrow (4) until it locks in place.
Upgrading the Management Blade Firmware
This section describes the procedures for
– Upgrading the management blade BMC via the LAN,
– Rebuilding the management blade default settings,
– Performing an emergency flash of the management blade firmware.
Upgrading the BMC via the LAN
The procedure described below is to be performed for each of both
!
management blades.
Requirements
– The blade server is connected to the power line.
– The management blade LAN port is connected to a client PC.
02
BX600
118
–
–
2
March 2006
Removal and Installation Routines
4
U41057-J21-Z146-1-76
3