Fujitsu PRIMERGY BX600 User Manual page 8

Features
Memory There are three memory banks available on each server
blade. These can be populated with 512 MB, 1 GB, 2 GB or
4 memory each with two DDR SDRAM modules. The
maximum memory expansion is 12 GB. ECC with memory
scrubbing function and hot-spare memory bank is standard.
Peripheral Special connector for 2xUSB and VGA port
interfaces
LAN avail- Each server blade has four Gigabit LAN channels. Usually two
ability channels are connected with the switch blades. Each switch
blade has ten 1-Gigabit downlink ports to connect and three
uplink ports for 10/100/1000 Base TX.
Fibre Channel Each server blade can be equipped with two 2 Gbit/sec Fibre
Channel I/O ports. For this purpose an FC daughter board
must be installed in the server blade. To use Fibre Channel
functionality at least one Fibre Channel pass-thru blade is also
required in the system.
PCI A server blade can be optionally provided with a proprietary
expansion expansion module for a standard full height half length PCI
module card via a PCI riser card. This PCI module will occupy the
space of the internal SCSI hard disk module on the left side of
the server blade.
Graphics Onboard video controller ATI Rage XL 8 MB onboard
controller
Storage Each server blade can accommodate two 3.5" SCA2 SCSI
hard disk drives (HDD) with 18, 36, 73 or 146 GB. The
maximum hard disk capacity on one server blade is 292
(2x146) GB in a RAID 0 configuration. Usually two disks are
mirrored in a RAID 1 configuration. Each server blade is
equipped with a two-channel Ultra 320 SCSI onboard
controller and embedded HostRAID.
02 BX600 8
– –
March 2006
General information
U41057-J21-Z146-1-76