Software Preparation - Fujitsu PRIMERGY BX600 User Manual

Installation and initial operation
1
Ê Press the KVM button (1) on the front panel of the server blade to route the
keyboard, mouse and monitor to the KVM blade.

Software preparation

Adjusting the CD-ROM drive
To install an operating system, you must boot the desired server blade from the
ServerStart CD-ROM. In some circumstances you will need to adjust several
settings to do this:
1 2
Ê Insert the ServerStart CD in the CD-ROM drive and press the power button
(2) on the front panel of the server blade.
Ê Press the KVM button (1) on the front panel of the server blade to route the
keyboard, mouse and monitor to the KVM blade. Wait a few seconds until
the monitor is activated.
U41057-J21-Z146-1-76
Server Blade Setup Using ServerStart
March 2006 02 BX600 41
– –