The Server Blade
Removal and Installation Routines
Ê Remove the hard disk module from the bay (3).
No jumper settings on the hard disk drives need to be adjusted.
i
If a hard disk drive module has been removed and no new module is installed
in its place, you should install a dummy module in the empty bay. Make sure that
the dummy module engages properly in the bay.
Installation
Installation of a hard disk drive module is performed in reverse order.
Exchangeable Drives
In needed, CD-ROM and floppy drives can be connected via USB. A USB port
is provided on the server blade front panel via a breakout cable (included in the
server system delivery pack). For more information on the server blade
expansion panel and breakout cable, see
page
02-BX600-25.
02
BX600
80
March 2006
–
–
U41057-J21-Z146-1-76