The Server Blade
Removal
Requirements
1
Ê Release the locking mechanism of the ejecting handles by pressing the
touch points on the inside of both handles (1) simultaneously. The ejecting
handles of the dummy module will be disengaged.
Ê Swing up the upper handle and swing down the lower handle simultaneously
(2) until the locking mechanism of the dummy module disengages and the
dummy module ejects.
Ê Remove the dummy module completely from the slot (3).
Keep the dummy module for future use. If the server blade is removed
!
and not replaced with a new server blade, then the dummy module must
be reinstalled for cooling and to comply with the applicable EMC regula-
tions (regulations on electromagnetic compatibility).
02
BX600
72
–
–
Removal and Installation Routines
2
March 2006
3
U41057-J21-Z146-1-76