Table of Contents
Advertisement
17.2 Storage Expansion - Scale
The last DE is the DE with the always highest identifier in the range of DE-1 to DE-a (i.e.
the always most recently added one). That means that expanding a system with at least
one already existing DE requires moving the end of the cable connected to CM#1 from
the IOM#1 IN port of the priorly last DE to the IOM#1 IN port of the new last DE.
The figures
"ETERNUS DX100 S3 cabling with one drive enclosure" on page 486
and
"ETERNUS DX100 S3 reverse cabling with two to ten drive enclosures" on page 487
are
depicting the cabling with a top down arrangement of the modules.
Figure 318: ETERNUS DX100 S3 cabling with one drive enclosure
486
ETERNUS CS800
Advertisement
Table of Contents
