Table of Contents
Advertisement
Figure 67: Entry System with 8 Gb/s Fibre Channel and with 10 Gb/s Ethernet
Proceed as follows to cable the system:
1. Connect a power cable to each power supply of the components.
2. If JX40 storage modules are available:
Connect the SAS IN port of the first JX40 module (labeled JX40-1) to the upper port of
the SAS RAID card in slot 7 of the server as shown by figure
Gb/s Fibre Channel and without 10 Gb/s Ethernet" on page
If there are further JX40 modules, connect the OUT port of the module JX40-1 to the IN
port of module JX40-2 and so forth.
ETERNUS CS800
CAUTION!
If JX40 storage modules are available: Ensure that at least one power supply unit
of each JX40 storage module and one power supply unit of the server are
connected with the same phase.
5 Installing the ETERNUS CS800 S6 Modules
"Entry System without 8
97.
99
Advertisement
Table of Contents
