Table of Contents
Advertisement
(segmentation):
At least one interface must allow management traffic.
Mgmt Select to allow management traffic.
Repl
Data
Any
Additional Information
l
l
7. Click Update to save the changes you made to the IP Address table. (Clicking Update
does not yet apply the new network settings to the ETERNUS CS800.)
8. Click Delete to remove IP address information for the selected interface. Or click Undo
to revert all current IP Address Table changes to the last update.
Configuring Interface Routing
Some network configurations require that you specify routing details for an interface. You
need to specify routing details if the host or client the interface connects to is on a different
subnet that is not reachable using the default gateway. You also need to specify routing
details if you have configured multiple network segments (replication, data, or management)
on the same subnet. For more information and examples, see
Under IP Address Configuration > Routing Details, enter routing information for one or
more interfaces (see
ETERNUS CS800
Select to allow replication traffic.
Select to allow data traffic.
Select to allow all types of traffic (management, replication, and data).
If the ETERNUS CS800 is configured for source or target replication, you should
configure at least one interface to allow replication traffic (select Repl or Any) before
applying changes to network settings.
If you configure segmentation for non-bonded interfaces (Ethernet ports) that are on
the same subnet, all traffic will use the lowest numbered Ethernet port first, no
matter how segmentation is configured. To avoid this issue, create bonded
interfaces, and then select the desired traffic type for each bonded interface.
When you add a network interface, a default route (via the default gateway) is
automatically created for the interface after network settings are applied and
the ETERNUS CS800 reboots. For example, if you add an interface with IP
address 10.20.185.172, a route with the destination IP address 10.20.185.0 is
automatically added. If you delete the default route, it is automatically added
again the next time network settings are applied and the ETERNUS CS800
reboots. For more information about interface routing, see
319.
"Network Page: Routing Details" on page
10 Configuration
"Network" on page
"Network" on page
319.
330):
329
Advertisement
Table of Contents
