Table of Contents
Advertisement
Completing installation
Figure 55: Sliding the server into the rack
1. Release the locking mechanism of both rails (1).
2. Push the server as far as it will go into the rack (2) until the Quick Release Levers (QRL)
engage (3).
5.2.2
Installing a Storage Module in the Rack
CAUTION!
Do not uninstall the drives that are installed by default or move them to any other slot.
Contact your sales representative or maintenance engineer if drives that are installed
by default need to be uninstalled or moved to another slot.
Attaching the Slide Rails to the Rack
The position of the 1HU support bracket is determined relatively to the base line of the
Storage Base Module.
1. Locate the positions of the screws and the M5 cage nut with the help of the following
figure.
ETERNUS CS800
Note that the QRLs are engaged properly on both sides.
CAUTION!
Be careful with your finger. You can pinch it if the QRL changes to the release
position.
5 Installing the ETERNUS CS800 S6 Modules
89
Advertisement
Table of Contents
