Table of Contents
Advertisement
17.2 Storage Expansion - Scale
Figure 316: Recommended Positions of the Modules in the Rack for Scale
CAUTION!
l
l
To add expansion modules make sure that you only use storage expansion
modules that are fully equipped and not manually configured. No preparations of
the ETERNUS DX100 S3 or the new expansion must be done. Just connect the
new expansion physically as described below and let the ETERNUS CS800 S6
software perform all steps necessary.
WARNING!
DO NOT run the "Add new enclosure" function provided by the ETERNUS DX100 S3.
Proceed as follows
1. Check the disks delivered with the new drive enclosure(s): Always 12 disks must be
inserted and they must be of the same size than used within the existing enclosures.
2. Verify if each of the already used ETERNUS DX100 S3 storage expansion modules is
correctly labeled with an identifier DE-x (x=1, 2, ..., 9, a). The position of the labels is
shown by figure below.
484
Install only system expansions that satisfy the requirements and rules governing
safety. If you install other expansions, you may damage the system or violate
these safety regulations. Information can be obtained from Fujitsu Technology
Solutions Customer Service or your local sales office.
If you cause a defect on the device by installing or exchanging system expansions
that are not released or qualified for ETERNUS CS800 S6, the warranty is
invalidated.
ETERNUS CS800
Advertisement
Table of Contents
