Fujitsu ETERNUS CS800 User Manual page 120

6.3 Running the Getting Started Wizard
Configuring Interface Details
Under IP Address Configuration > Interface Details, configure jumbo Ethernet frame
settings for each port or device (see
Figure 83: Network Page: Interface Details
1. If necessary, click the Show link to show the interface details table.
2. For each device, select the MTU (Maximum Transmission Unit) frame size in the
Jumbo Frame MTU Size drop-down box.
1500 MTU
9000 MTU
3. Click Update to save the changes you made to the Interface Details table. (Clicking
Update does not yet apply the new network settings to the ETERNUS CS800.)
4. Click Undo to revert to all current Interface Details changes to the last update.
Configuring Interface IP Addresses
Under IP Address Configuration > IP Address Table, configure one or more network
interfaces for each port or device (physical Ethernet port or bonded device) (see
Page: IP Address Table" on page
120
"Network Page: Interface Details" on page
(Default) The standard (STD) MTU frame size of 1,500 bytes is
used.
The jumbo MTU frame size of 9,000 bytes is used. (For best
performance, make sure the entire network path to the ETERNUS
CS800 is configured to use 9000 MTU.)
121):
120):
"Network
ETERNUS CS800