Fujitsu ETERNUS CS800 User Manual page 448

14.3 Analyzer
2. Click Start.
The throughput result is displayed under Result From Last Run in MB/s.
Settings
The Settings page allows you to enable or disable NetServer on the ETERNUS CS800.
NetServer must be enabled on the target ETERNUS CS800 system to perform network
analysis with the system (see
To access the Settings page, on the Network Analyzer page, click the Settings tab (see
"Settings Page" on page
Figure 288: Settings Page
To enable or disable NetServer on the target ETERNUS CS800:
1. Select Enable NetServer to enable NetServer.
Or select Disable NetServer to disable NetServer.
2. Click Apply.
You should disable NetServer on the target system when you are done analyzing
network performance.
Disk Analyzer
The Disk Analyzer page allows you to analyze disk performance by measuring disk read
and write throughput.
To access the Disk Analyzer page, on the Analyzer page, click the Disk tab (see
Analyzer Page" on page
448
It takes approximately 5 seconds to refresh the results.
"Performance" on page
448).
449).
447).
ETERNUS CS800
"Disk