Table of Contents
Advertisement
11.2 Replication Send
Replication" on page 390
Replication" on page
2. On the source ETERNUS CS800, select the source share or partition and click
Configure.
The Share or Partition Configure window displays (see
Window" on page
Figure 237: Share or partition Configure Window
3. If it is not already selected, select the Enable Replication check box to enable
replication for the share or partition.
4. Select the Enable Directory/File or Cartridge Based Replication to target to target
check box to enable Directory/File or Cartridge Based Replication for the share or
partition.
Or clear theEnable Directory/File or Cartridge Based Replication to target to target
check box to disable Directory/File or Cartridge Based Replication for the share or
partition.
5. Enter a Sync ID in the box.
The Sync ID is used to identify the target share or partition that will receive replicated
data from the source share or partition. The Sync IDmust be identical to the Sync ID of
the target share or partition on the target system.
The Sync ID must contain no more than 32 characters (NAS share) or 12 characters
(VTL partition) and can contain only alphanumeric characters, underscores, and
hyphens. (An underscore or hyphen must not be the first character.)
376
or
401.)
376).
If you are performing Directory/File or Cartridge Based Replication with a
system running an ETERNUS CS800 software version prior to 2.3, you may
need to change the Sync ID on the system running pre-2.3 software to match
the above Sync ID name restrictions.
"Configuring a Target Partition for Cartridge Based
"Share or partition Configure
ETERNUS CS800
Advertisement
Table of Contents
