1. Under Target System, click the box next to Throttling.
The Replication Throttle window displays (see
Figure 180: Replication Throttle
2. Select the Enable system throttling check box, or clear the check box to disable
system throttling.
3. In the Throttle box, enter the maximum allowed bandwidth, and select the units you
want to use to specify the constant throttle
(KB/s or MB/s). The lowest value you can set is 32 KB/s. The lowest value you can set
is 32 KB/s. The highest value you can set is 125 MB/s for 1GbE and 500 MB/s for
10GbE.
4. Click Apply.
CAUTION!
Do not set the maximum allowed bandwidth to a value that is lower than necessary. If
the maximum allowed bandwidth is set to the lowest value, large replication jobs may
fail.
ETERNUS CS800
"Replication Throttle" on page
10 Configuration
277).
277