Table of Contents
Advertisement
Additional Information
Before you can add a replication target, you must add the ETERNUS CS800 to the list of
l
allowed replication sources on the target ETERNUS CS800 (see
Source" on page
To add a new target when two targets are already configured, first delete one target (see
l
"Deleting a Replication Target" on page
For more information about enabling and scheduling replication for a share or partition,
l
see
To add a replication target:
1. Under Target System, click Add.
The Add Target Host window displays (see
Figure 178: Add Target Host
2. In the Target Hostname or IP box, enter the hostname or IP address of the system that
will receive the replicated data.
When entering IP addresses, never use an address that is in a reserved IP address
range. To see a list of reserved IP address ranges, click the quick tip icon [?] located
near the IP address field.
To use hostname format, you must specify at least one DNS IP address on the Network
page (see
3. In the Encryption drop-down box, select the type of encryption to use when sending
replication data to the target system (None, 128-bit, or 256-bit).
4. In the Source IP box, enter the IP address that is used to uniquely identify the source
ETERNUS CS800
278).
"Replication Send" on page
"Network" on page
CAUTION!
For encryption, select None or 128-bit if you are sending data to a ETERNUS
CS800 running a system software version prior to ETERNUS CS800 2.1.1
Software.
AES encryption options are available only if the Data-in-Flight license is
installed.
276). Then add the new target.
371.
"Add Target Host" on page
319).
10 Configuration
"Adding a Replication
273).
273
Advertisement
Table of Contents
