Entry System With Eternus Jx40 S2 Option - Fujitsu ETERNUS CS800 User Manual

Hide thumbs Also See for ETERNUS CS800:

Table of Contents

5.3 Cabling the ETERNUS CS800 S6 System

Figure 63: Entry System with 8 Gb/s Fibre Channel and with 10 Gb/s Ethernet

Proceed as follows to connect theETERNUS CS800 S6 Entry:

1. Connect a power cable to each power supply of the server.

2. Connect the LAN ports and optionally the iRMC port to the appropriate networks. At

least one of the LAN ports must be connected.

3. If your CS800 also provides FC ports: Connect them to the SAN or directly to the

appropriate devices.

Entry System with ETERNUS JX40 S2 Option

There are four different versions of the Entry model with the JX40 option, which can be

distinguished by the ports respectively the PCI slots used in the server, see table

PCI Slots - Entry System, with JX40 S2 option" on page

Optionally up to three ETERNUS JX40 S2 storage modules can be connected to the server

to provide a disk capacity of more than 24TB (up to 120TB).

Please refer to the pictures below to identify the model and to see which ports can be

connected to the LAN and SAN and how to connect the optionally available JX40 modules.

ETERNUS CS800