Table of Contents
Advertisement
10.8 Notifications
IP Address /
Network Mask
10.40.166.87
10.40.166.0
10.40.166.87
255.255.0.0
10.40.0.0
255.255.0.0
Additional Information
l
l
4. In the Access Type drop-down box, select the access type for the community:
Get
Get/Set
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply.
Editing a Community
Edit an SNMP community to change the IP address or access type for the community. You
can also enable or disable the community.
To edit a community:
1. Select SNMP destination and click Edit.
The Edit SNMP Community page displays (see
page
312
Result
Invalid because the logical bitwise operation (address AND mask)
is not equal to the address
Invalid because the logical bitwise operation (address AND mask)
is not equal to the address
Allows access from any client with address 10.40.xx.xx
If you define a single community and set both the IP address and network mask to
0.0.0.0 (or leave both blank), then IP address-based access control is disabled. In
this case, the SNMP agent is accessible from any IP address.
When entering IP addresses, never use an address that is in a reserved IP address
range. To see a list of reserved IP address ranges, click the quick tip icon [?] located
near the IP address field.
Allows SNMP get operations.
Allows both SNMP get and put operations.
313).
"Edit SNMP Community Page" on
ETERNUS CS800
Advertisement
Table of Contents
