Table of Contents
Advertisement
6. Select the check box for each replication target you want to replicate the share or
partition to. (You must select at least one target.) When the share or partition is
replicated, its data will be sent to all selected targets.
7. Click Apply.
After you configure a share or partition for Directory/File or Cartridge Based
Replication, you should synchronize it to ensure it is in sync with the target share
or partition (see
Replicating a Share or Partition
Replicate a NAS share or VTL partition to send a snapshot of the share or partition to the
target systems. A snapshot is required to recover the data on the targets at a later time. If you
have not configured a replication schedule for a share or partition, replication only occurs
when you manually initiate it.
CAUTION!
Do not replicate a partition containing media in an Exported state.
To replicate a share or partition:
1. Select the share or partition to replicate.
If multiple targets are configured, click the arrow next to the share or partition to display
all targets, and then select the desired target.
2. Click Replicate Now.
The status of the replication job displays in the Job Status column.
To cancel the replication job, select the share or partition and click Abort.
Synchronizing a Share or Partition
Synchronize a NAS share or VTL partition to synchronize its contents with the corresponding
share or partition on the target systems. To synchronize a share or partition, it must be
configured for Directory/File or Cartridge Based Replication (see
or Cartridge Based Replication" on page
Synchronizing a share or partition ensures that the contents of the source share or partition
are the same as the target share or partition. The synchronization verifies that the same files
or cartridges exist in both locations, and that no additional files or cartridges exist in either
location.
You should perform a synchronization in any of the following situations:
ETERNUS CS800
Directory/File or Cartridge Based Replication will be configured for all
selected targets. You cannot configure one share or partition for multiple
replication types.
"Synchronizing a Share or Partition" on page
375).
11 Replication
377).
"Configuring Directory/File
377
Advertisement
Table of Contents
