Table of Contents
Advertisement
In this example, you would specify the following routing details for the replication interface on
the source ETERNUS CS800:
Destination
Dest
Netmask
Dest
Gateway
Figure 213: Interface Routing: Example 2
Example 3: Segments on the Same Subnet and Target on a Different Subnet
In the example below (see
CS800 has two segmented interfaces, one for data and management traffic, and one for
replication traffic:
The source ETERNUS CS800 management/data IP address and the source ETERNUS
l
CS800 replication IP address are on the same subnet (192.168.10.x). The target
ETERNUS CS800 IP address is on a different subnet (192.168.20.x)
To make sure the replication segment is used when communicating with the target
l
ETERNUS CS800, you must add a network route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify the following routing details for the replication interface on
the source ETERNUS CS800:
Destination
Dest Netmask
Dest Gateway
In addition, to enable communication with the target ETERNUS CS800 by means of the
l
gateway, you must add a second host route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify a second set of routing details for the replication interface
on the source ETERNUS CS800:
ETERNUS CS800
Use the IP address of the target ETERNUS CS800 (192.168.10.200).
Use 255.255.255.255.
Use the replication IP address of the source ETERNUS CS800
(192.168.10.100).
"Interface Routing: Example 3" on page
Use the subnet of the target ETERNUS CS800 (192.168.20.0).
Use 255.255.255.0.
Use the IP address of the gateway (192.168.10.1).
10 Configuration
334), the ETERNUS
333
Advertisement
Table of Contents
