Table of Contents
Advertisement
1155SBS050402A
2) Tech. Rep. Choice
•
This function allows the Tech. Rep. to make the various settings and adjustments.
<Functions>
1) System Set: Used for setting the choice functions concerning the operating environment of the sys-
tem.
2) Printer: Used for setting the choice functions concerning the printer.
<Setting Procedure>
1. Touch [Tech. Rep. Choice] to open a screen to select System or Printer.
2. Touch either [System] or [Printer] as necessary.
3. Select the particular choice function to be set.
<System Set>
Touch Panel Display
FLS Paper
Auto Paper Config.
Printer Time Out
Touch Panel Adj.
Maintenance Call
Tech. Rep. Mode
Setting (The default is
Set the size for FLS.
F : 330.2mm
C : 203.2mm
Select either "Inch/Metric" or "Metric" for rounding off the original size
detected.
Inch / Metric
Metric
Set the time for communication detection between the copier and Pi6000 if a
Pi6000 is connected. If "Disable" is selected, communication detection is not
made.
Note: A malfunction code appears on the Touch Panel if no communications
are carried out between the copier and Pi6000 within the set period of
time.
(1 to 99)
(Disable)
Correct the deviation in the sensitive area of the Touch Panel.
<Procedure>
1. Touch the four points (marked with +) on the screen in any sequence.
2. The + markers change into grid markers and, when the [End] key is
touched, the deviation is corrected.
Note: Touch [Cancel] to nullify or cancel the adjustment.
Select whether or not to give the Maintenance Call when the Consumables
counter reaches the preset count.
Call Indicated
S-29
Tech. Rep. Choice
Highlighted
F : 330mm
F : 330.2mm
C : 210mm
C : 215.9mm
The measurement is rounded to the
nearest standard inch or metric size.
The measurement is rounded to the
nearest standard metric size.
Call Not Indicated
.)
F : 330mm
C : 220mm
(10 min.)
Advertisement
Chapters
Table of Contents
