Minolta Di 620 Manual page 363

6. Remove one screw and the gear holder at the front of the Developing Unit.
7. Unplug one connector and remove four gears.
8. Remove two screws and the Sub Hopper Toner Replenishing Motor.
9. Snap off the E-ring and remove the bushing for the Developer Conveying/Agitating Screw.
10. Remove two screws and the bushing for the Bucket Roller.
11. Remove four screws and the gear holder at the rear of the Developing Unit.
12. Remove seven gears (three shafts).
NOTE
When reinstalling the bushing, twist it into position.
1155D087AB
D-52
1155D086AB
1075D223AA