Adjustment Of The Paper Exit Timing Belt; Adjustment Of The Scanner Motor Timing Belt; Adjustment Of The 3Rd Drawer Timing Belt - Minolta Di 620 Manual

Hide thumbs Also See for Di 620:

Table of Contents

6) Adjustment of the Paper Exit Timing Belt

1. Remove the Rear Cover.

2. Remove five screws and the Fusing Unit Drive Assy.

3. Loosen the screw by which the Tension Lever is mounted

as shown on the left and then re-tighten it.

1. Remove the Rear Cover and Upper Rear Cover.

2. Loosen four screws on the Scanner Motor mounting

bracket and then re-tighten them.

1. Pull out the 3rd Drawer and remove it.

2. Lift up the Main Tray and remove the two screws by which

the Shift Tray is fixed.

Be careful, the Main Tray wire easily comes off at

3. Release the lock by pressing the lock lever of the Shift Tray

using a screwdriver, etc., as shown on the left.

4. Remove the Shift Tray.

Table of Contents