Table of Contents
Advertisement
Touch Panel Display
RD Mode
Copy Track
DT Setting
CT-ID
DT-ID
TEL No.
Initial Transmission
RAM Clear
Common DT
Dial Mode
Auto Receive
Result Code
Report Format
Tech. Rep. Mode
Setting (The default is
Used to make the initial settings and various transmissions.
Enter the following data.
Enter the 4-digit ID number of the Center which has been programmed in
the Center personal computer.
Enter the 6-digit ID number of the Data Terminal.
Enter the 19-or-less-digit phone number of the modem connected to the
Center personal computer.
Note 1: When the office extension and outside line use different systems,
enter "P" for a "pulse" telephone line or "T" for a "tone" telephone
line before the outside line number.
Note 2: The time it takes the private branch exchange (PBX) system to
switch from the extension line to the outside line varies depending
on the type of PBX system used.
Set this time as follows.
Fixed switching time: Enter the pause code "-" (a single "-" lasts 2
sec.)
Varying switching time: Enter the wait code "W".
Used to perform the initial transmission from the PPC to the Center to
check for correct communication when the Data Terminal has been set up.
Reinitializes the Data Terminal.
YES
Set the following functions.
Select the type of telephone line of the user.
Tone
Choose "Yes" or "No" for the auto reception function.
YES
Note: Select "Yes" if the line is dedicated to the Data Terminal.
Enter the result code for connection to the modem when the line is con-
nected. (0 to 9999)
Japan only.
10 Bit
S-46
RD Mode
Highlighted
Pulse
11 Bit
.)
NO
NO
Advertisement
Chapters
Table of Contents
