Replacement Of The Cleaning Blade - Minolta Di 620 Manual

12) Replacement of the Cleaning Blade

When the Cleaning Blade has been replaced, perform the following steps.
A
When securing the Toner Antispill Seal, try to press it in
the direction of the arrow.
1155D215AA
1. Remove the PC Drum and Main Erase Lamp.
2. Unhook the spring.
3. Remove two shoulder screws, one spring, and one cap,
and remove and replace the Cleaning Blade.
1155D072AB
1. Before installing the PC Drum, apply lubricant (shipped
with the new Cleaning Blade) to the cleaning felt pads at
both ends of the PC Drum. Also apply toner to the entire
surface of the Cleaning Blade.
1075D098AA
2. Install the PC Drum and apply a thin coat of toner to the
surface of the PC Drum.
1075U047AA
3. Holding onto both ends of the PC Drum, turn the PC Drum
1/2 turn in the direction of arrow A, then turn it one turn in
the direction of arrow B.
B
4. Reinstall the PC Unit.
1075D099AA
NOTE
D-45