Minolta Di 620 Manual page 351

9. Mount the drive support plate.
10. Mount the SCP Board.
11. Install the Scanner Motor and timing belt. Then, make the Scanner Motor timing belt adjustment.
12. Mount the Scanner and adjust the positions of the Scanner and 2nd/3rd Mirrors Carriage.
NOTE
When the Scanner Drive Cables have been replaced, perform Zoom (FD) Adjust, Zoom (FD)
Manual, Scale (FD) and Pos./Zoom (FD).
NOTE
When winding the cable around pulley B, place the
length of the cable on the cylindrical stopper end at the
front and the length of the cable on the mounting bracket
end in the rear.
1155D066AB
7. Fit the cable into the Cable Guide Groove, hook on the
spring, and secure it in position.
1155D067AA
8. Remove the Cable Holding Jig.
1155D068AB
D-40