Adjust Function Setting Procedure - Minolta Di 620 Manual

1155SBS0703A

7-3. Adjust Function Setting Procedure

<Functions>
1) Printer .....Used for entering the Adjust values concerning the printer.
2) IR ............Used for entering the Adjust values concerning the IR.
3) EDH ........Used for entering the Adjust values concerning the EDH.
<Setting Procedure>
1. Set the copier into the Tech. Rep. mode by one of the following methods :
1) With the copier turned ON, press the Tech. Rep. Setting Switch.
2) With the Meter Count screen opened from Utility, press the following keys in this order.
Stop Key
2. Enter the Adjust mode by pressing the following keys in this order :
Stop Key Start key
3. Select the particular Adjust function to be set.
4. Make the necessary settings by following the instructions given sequentially on the screen.
Note: The function selected is highlighted.
<Exiting Mode>
Perform any one of the following steps to go back to the Basic screen.
1) Press the Panel Reset key and Touch [Exit] on the Tech. Rep. Mode screen.
2) Touch [Menu] on the Adjust screen. Then touch [Exit] on the Tech. Rep. Mode screen.
<Printer>
Touch Panel Display
Registration (CD)
Registration (FD)
Zoom (FD) Adjust
0 0
Tech. Rep. Mode
Setting (The default is
Adjust registration of the printer in the main scanning direction by changing
the timing at which the laser beam strikes the PC Drum.
1st
2nd
3rd
4th
Manual
LCC
Duplex
600dpi
Note: The press of the Start key causes the copier to output a test pattern
using the paper source currently selected for use.
Adjust registration of the printer in the sub-scanning direction by changing the
timing at which the Synchronizing Roller is started.
400dpi
600dpi
Note: The press of the Start key causes the copier to output a test pattern
using the paper source currently selected for use.
Adjust the zoom ratio for the printer in the sub-scanning direction by changing
the speed of the Synchronizing Roller and the PC Drum Drive Motor.
Note: The press of the Start key causes the copier to output a test pattern
using the paper source currently selected for use.
S-53
Stop Key
Adjust
Highlighted
−8.2
0
(Advanced
timing)
−8.2
0
(Advanced
timing)
(−3 to +3) (0mm)
0 1
.)
+8.2
(Retarded
timing)
+8.2
(Retarded
timing)