Table of Contents
Advertisement
Touch Panel Display
I.R. & EDH Check
Function (EDH)
S-ADF Mode (FD)
Skew Check
Tech. Rep. Choice
Erasure Width
ID in Photo Mode
Skew Detection
Tech. Rep. Mode
Adjusts the scanning position (FD) for a single feed scan.
Note: The Touch Panel shows "OK" if the adjustment value falls within the
specified range, and "NG" if it falls outside the range. It gives the
message of "Unable" if the adjustment sequence is abnormally ter-
minated.
<Procedure>
1. Insert the chart into the Single Feed Tray, which starts the measurement
cycle. (There is no need of pressing the Start key.)
2. If the measurement result is okay, touch [Save] (which highlights the
key) to save the measurement.
Note: The copier automatically stops as soon as it completes the measure-
ment cycle. The Stop key may, however, be pressed to halt the
sequence.
Checks the EDH for correct alignment and shows the results.
Note 1: The Touch Panel shows "OK" if the copier is able to take measure-
ments successfully and "Unable" if it fails.
Note 2: The message "OK" merely indicates that the copier has been able
to take measurements, providing no criteria for determining if the
specifications are met or not.
<Procedure>
1. Load the chart in the EDH.
2. Press the Start key to start the measurement cycle.
Note: The copier automatically stops as soon as it completes the measure-
ment cycle. The Stop key may, however, be pressed to halt the
sequence.
Allows the Tech. Rep. to set, check, adjust, and program the various Tech.
Rep. functions.
Set the fixed erasure width from the Original Width Scale and Original
Length Scale to erase shadows which are otherwise produced by the
scales.
Set the image quality for the special mode.
0
Normal mode
Note 1: Only when any number from 1 to 9 is set, the special image quality
mode key "*" appears on the Density screen.
Note 2: The special mode is for expansion of functions.
Set the angle of skew to serve as the reference for giving a skew original
warning.
Note: The skew original warning is given if the set angle is exceeded with
"Realign Warning" of User's Choice turned ON.
Strick
4mm / 210mm
S-43
I.R. & EDH Check
Setting
(0 to 5)
(3mm)
Special mode
Standard
8mm / 210mm
1 to 9
Loose
16mm / 210mm
Advertisement
Chapters
Table of Contents
