Table of Contents
Advertisement
19) Scale (CD)
Requirement
Adjust so that the leading edge of the image of the scale on the copy sample falls within the
specified range with respect to the Original Width Scale.
Specification
0 ± 0.5 mm
NOTES
1) This adjustment must be made when the CCD Unit or Original Glass has been replaced.
2) After the adjustment, be sure return Erasure Width and Registration on the printer side to the
original values.
Adjustment Procedure
2. Set Erasure Width to 0. (See p. D-102 for the erase width setting procedure.)
3. Set the registration of one paper source of Registration (CD) on the printer side to +5.0. (See p. D-
91 for the registration setting procedure.)
4. Touch [END] and press the Interrupt key to set the copier into a test print mode.
5. Press the Start key to make a copy.
7. Call the Adjust mode to the screen.
8. Touch the [IR] Key to highlight "Scale (CD)".
Adjust Mode
Scale (CD)
1. Place a scale on the Original Glass so that it runs parallel
with the Original Width Scale and its leading edge is
aligned with the Original Length Scale.
1155D164AA
6. Check to see if the leading edge position of the image of
the scale on the copy falls within the specifications with
respect to the Original Width Scale.
If it is outside the specified range, perform the following
adjustment steps.
1155D165AA
D-108
Setting Range
-7.0 to +7.0
Advertisement
Chapters
Table of Contents
