Minolta Di 620 Manual page 318

No. Part Name
1 Front Lower Door
2 Front Upper Door
3 Control Panel Unit
4 Original Glass
5 Upper Rear Cover
6 Glass Holder
EDH Original
7
Glass
8 Upper Right Cover
9 Right Upper Cover
10 Right Rear Cover
Right Door
11
(Multi Bypass Unit)
12 Right Front Cover
13 Front Right Cover
14 3rd Drawer
15 2nd Drawer
16 1st Drawer
17 Front Left Cover
23 Left Front Cover
18 EDH
19 Upper Left Cover
20 Left Upper Cover
21 Left Upper Door
22 Left Lower Door
24 Left Rear Cover
25 Rear Cover
Swing down No. 1. → Remove two screws that secure the belt. →
Remove four screws that secure the Front Lower Door.
Swing down No. 2. → Remove one screw that secures the belt. →
Remove four screws that secure the Front Upper Door.
See p. D-8.
Swing down No. 2. → Open No.18 → Remove No. 9. → Remove
No. 8. → Remove No. 6.
Remove No.18. → Remove three screws that secure the Upper Rear
Cover.
Swing down No. 2. → Open No.18. → Remove No. 9. → Remove
No. 8. → Remove four screws that secure the Glass Holder.
Swing down No. 2. → Open No.18. → Remove No. 9. → Remove
No. 8. → Remove No. 6.
Swing down No. 2. → Open No.18. → Remove No. 9. → Remove
three screws that secure the Upper Right Cover.
Swing down No. 2. → Remove three screws that secure the Right
Upper Cover.
Remove three screws that secure the Right Rear Cover.
Remove No.10. → Remove the harness from two wiring saddles. →
Unplug three connectors. → Remove one ground wire mounting
screw → Open the Right Door and pull it up.
Swing down No.1. → Remove two screws that secure the Right Front
Cover.
Slide out all paper drawers. → Remove two screws that secure the
Front Right Cover.
See p. D-25.
Slide out the drawer and then, lifting it slightly up, pull it out of posi-
tion.
Slide out all paper drawers. → Remove four screws that secure the
Front Left Cover and Left Front Cover. (The Front Left Cover and Left
Front Cover are secured by means of metal plates.)
Unplug one connector. → Remove two screws that secure the EDH.
Remove No. 5. → Remove one screw that secures the Upper Left
Cover.
Swing down No. 1, 2. → Open No. 21. → Remove two screws that
secure the Left Upper Cover.
See p. D-66.
Remove four screws and the Left Lower Door Cover. → Remove the
harness from one wiring saddle. → Unplug one connector. →
Remove one ground wire mounting screw → Open the Left Lower
Door and pull it up.
Remove three screws that secure the Left Rear Cover.
Remove seven screws that secure the Rear Cover.
D-7
Removal Procedure