Caution – Equipment damage possible. The covers must be in place for proper
airflow.
For your protection, observe the following safety precautions when setting up your
equipment:
Follow all cautions, warnings, and instructions marked on the equipment and
■
described in the Important Safety Information for Sun Hardware Systems (821-1590).
Follow all cautions, warnings, and instructions marked on the equipment and
■
described in the Sun Fire X4170 M2 and X4270 M2 Servers Safety and Compliance
Guide.
Ensure that the voltage and frequency of your power source match the voltage
■
and frequency inscribed on the equipment's electrical rating label.
Follow the electrostatic discharge safety practices as described in this chapter.
■
2.2
Required Tools
The Sun Fire X4270 M2 Server can be serviced with the following tools:
Antistatic wrist strap
■
Antistatic mat
■
4 mm Hex wrench
■
No. 2 Phillips screwdriver
■
Straight-edge screw driver
■
Stylus or pencil (to power the server on and off and to press the CLEAR CMOS
■
button)
2.3
Obtaining the Chassis Serial Number
To obtain support for your server, you need your chassis serial number. The chassis
serial number is located on a sticker on the front of the server and on another sticker
on the top of the server.
2-2
Sun Fire X4270 M2 Server Service Manual • May 2011
Need help?
Do you have a question about the Sun Fire X4270 M2 and is the answer not in the manual?