Sun Oracle Sun Fire X4270 M2 Service Manual page 181

7. Press Enter for the new value to take effect.
The Preboot Menu asks you to confirm your changes.
Enter 'y[es]' to commit changes: [no]
8. Type y to save your changes and exit the edit session.
If you want to exit the edit session without saving your changes, type n.
9. To exit the Preboot Menu, type boot.
The following example shows an edit session where the
check_physical_presence settings are changed.
Note – For a list of other settings you can edit in the Preboot Menu, see
Section 7.2.1.4, "Edit Mode Settings in Preboot Menu" on page
Preboot> edit
Press Enter by itself to reach the next question.
Press control-C to discard changes and quit.
Values for baudrate are {[ 9600 ]| 19200 | 38400 | 57600 | 115200 }.
Set baudrate?
Values for serial_is_host are {[ 0 ]| 1 }.
Set serial_is_host?
Values for bootdelay are { -1 | 3 | 10 | 30 }.
Set bootdelay?
Set bootdelay?
Values for bootretry are { -1 | 30 | 300 | 3000 }.
Set bootretry?
Values for diags_mode are {[ Normal ]| Quick | Extended | Skip }.
Set diags_mode?
Values for preferred are {[ 0 ]| 1 }.
Set preferred?
Values for preserve_conf are {[ yes ]| no }.
Set preserve_conf?
Values for check_physical_presence are {[ yes ]| no }.
Set check_physical_presence? [yes] no
Set check_physical_presence? [no]
Enter 'y[es]' to commit changes: [no] y
Summary: Changed 2 settings.
Preboot>
Chapter 7
[9600]
[0]
[3] 10
[10]
[-1]
[Normal]
[<not set>]
[yes]
Troubleshooting the Server and Restoring ILOM Defaults
7-10.
7-9