Sun Oracle Sun Fire X4270 M2 Service Manual page 156

c. Attach an antistatic wrist strap.
d. Remove the top cover.
2. Remove the rear-mounted boot disk drive cage (
a. Loosen the two captive Phillips screws on the ends of the PCI crossbar [1].
b. Grasp both ends of the PCI crossbar and pull it to the rear to disengage it
c. Disconnect the two SATA cables connectors from the rear of the boot disk
d. Disconnect the power cable from the rear of the boot disk drive cage [2].
e. Remove the two green captive screws that secure the boot disk drive cage to
f. Lift the cage up and out of the chassis [4].
3. Place the cage on an antistatic mat.
5-28 Sun Fire X4270 M2 Server Service Manual • May 2011
See Section 2.9, "Performing Electrostatic Discharge and Antistatic Prevention
Measures" on page 2-31.
See Section 2.10, "Removing the Server's Top Cover" on page
from the chassis and then lift it up and out of the chassis [1].
drive cage [2].
the server chassis [3].
2-33.
).
FIGURE 5-11