Logout; Ping; Create Time_Range - D-Link DGS-1100-16/ME Reference Manual

logout

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To terminate the current user's Telnet session:

ping

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To ping the IP address 10.90.90.100 three times:

create time_range

Purpose
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
To log out a user from the Switch.
logout
The logout command terminates the current user's session on the
Switch.
None.
None.
DGS-1100-24P/ME:admin#logout
To test the connectivity between network devices.
ping <ipaddr> {times <value 0-255> | timeout <sec 1-99> }
The ping command sends Internet Control Message Protocol
(ICMP) echo messages to a remote IP address. The remote IP
address then 'echos' or returns the message. This is used to confirm
connectivity between the Switch and the remote device.
<ipaddr> - The IP address of the host.
times <value 0-255> - The number of individual ICMP echo
messages to be sent. The maximum value is 255. The default is 4.
timeout <sec 1-99> - The time-out period while waiting for a
response from the remote device. A value of 1 to 99 seconds can be
specified. The default is 1 second.
None.
DGS-1100-24P/ME:admin#ping 10.90.90.100 times 3 timeout 3
Command : ping 10.90.90.100 times 3 timeout 3
Reply from 10.90.90.100, time=3ms
Reply from 10.90.90.100, time=3ms
Reply from 10.90.90.100, time=2ms
Ping Statistics for 10.90.90.100
Packets: Sent =3, Received =3, Lost =0
DGS-1100-24P/ME:admin#
To configure the time range on the Switch.
26