Config Ipif System; Logout - D-Link DGS-1210-10 Manual

6 Command Line Interface
Example usage:
To configure the IP interface System:
DGS-1210-52MP> config ipif System ipaddress 10.48.74.122/8
Success.
DGS-1210-52MP>

config ipif system

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IPv6 interface System:
DGS-1210-52MP> config ipif System ipv6 ipv6address 3ffe:501:ffff:100::1/64
Success.
DGS-1210-52MP>

logout

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To terminate the current user's console session:
DGS-1210-52MP> logout
To configure the System IPv6 interface.
config ipif <ipif_name> { ipv6 ipv6address
<ipv6networkaddr> | dhcpv6_client [enable | disable] }
The config ipif system command configures the System IPv6
interface on the Switch.
<ipif_name> − Specifies the ipif name to be configured.
ipv6 ipv6address <ipv6networkaddr> − Use this parameter to
statically assign an IPv6address to this interface. This address
should define a host address and a network prefix length.
Multiple IPv6 addresses can be configured for a single IP
interface. Ex: 3ffe:501:ffff:100::1/64. The /64 represents the prefix
length of the IPv6 addresses.
dhcpv6_client [enable | disable] − Specifies the DHCPv6 client to
be disabled or enabled.
None.
To log out a user from the Switch's console.
logout
The logout command terminates the current user's session on
the Switch's console.
None.
None.
1 4 1
1 4 1
D-Link Smart Managed Switch User Manual