Show Syslog Host - D-Link DGS-1100-16/ME Reference Manual

Restrictions
Example usage:
To configure a syslog host:

show syslog host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show Syslog host information:
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
local1 − Specifies that local use 1 messages are to be sent to the
remote host. This corresponds to number 17 from the list above.
local2 − Specifies that local use 2 messages are to be sent to the
remote host. This corresponds to number 18 from the list above.
local3 − Specifies that local use 3 messages are to be sent to the
remote host. This corresponds to number 19 from the list above.
local4 − Specifies that local use 4 messages are to be sent to the
remote host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages are to be sent to the
remote host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages are to be sent to the
remote host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages are to be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that
the syslog protocol is to be used to send messages to the remote
host. The range of udp port number is 514, 1024-65535.
ipaddress <ipaddr> − Specifies the IPv4 address of the remote host
to which syslog messages are to be sent.
state [enable | disable] − Allows the sending of syslog messages to
the remote host, specified above, to be enabled and disabled.
Only administrator-level users can issue this command.
DGS-1100-24P/ME:admin#config syslog host severity all
Command : config syslog host severity all
Success.
DGS-1100-24P/ME:admin#
To display the syslog hosts currently configured on the Switch.
show syslog host
The show syslog host command displays the syslog hosts that are
currently configured on the Switch.
None.
None.
DGS-1100-18/ME:admin#show syslog host
Command : show syslog host
Syslog Global State : Enabled
58