Config Jumbo_Frame - D-Link DGS-1100-16/ME Reference Manual

DGS-1100-24P/ME:admin#show config current_config
Command : show config current_config
#
#
#
#
#
#BLOCK_UNKNOWN_MULTICAST#
disable block_unknown_multicast
#MIRROR#
disable mirror
#MULTICAST FILTER#
#VOICE VLAN#
config voice_vlan priority 5
config voice_vlan aging_time 720
config voice_vlan ports list 1-24 mode autountagged
#SURVEILLANCE_VLAN VLAN#

config jumbo_frame

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable jumbo frames:
DGS-1100-24P/ME:admin#config jumbo_frame ports 1-5 state
enable
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
DGS-1100-24P/ME Gigabit Ethernet Switch
Configuration
Firmware: Build 1.00.L001
Copyright(C) 2014 D-Link Corporation. All rights reserved.
To configure jumbo frames on the device.
config jumbo_frame ports <portlist> state [enable | disable]
The config jumbo_frame command can enable or disable jumbo
frames on the device by ports.
<portlist> - A port or range of ports to be configured.
state – Allows the user to enable or disable jumbo frame function for
the by ports.
Only administrator-level users can issue this command.
Jumbo frames will be enabled after saving and restarting the
system.
22