Eee; Config Eee - D-Link DGS-1100-16/ME Reference Manual

The EEE commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

config eee

show eee
Each command is listed in detail, as follows:
config eee
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable eee in port 3:
DGS-1100-24P/ME:config eee portlist 3 state enable
Command : config eee portlist 3 state enable
Success.
DGS-1100-24P/ME:admin#
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[portlist <portlist> | all] state [enable | disable]
{portlist <portlist>}
Used to configure eee function on the switch.
config eee [portlist <portlist> | all] state [enable | disable]
The config eee command is used to enable/disable the eee function
on special port(s) on the switch.
Note: The EEE feature is only supported on the copper ports on all
DGS-1100/ME Series switches.
portlist <portlist> - Specified a range of ports to be configured.
(UnitID: port number).
all - For set all ports in the system, you may use "all" parameter.
state - Specified the eee state. The default state is disabled.
enable: Enable the eee function on the special port.
disable: Disable the eee function on the special port.
Only administrator-level users can issue this command.
166
34

EEE