Link Aggregation Commands; Create Link_Aggregation - D-Link DGS-1100-16/ME Reference Manual

The Link Aggregation commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

create link_aggregation

delete link_aggregation
config link_aggregation
show link_aggregation
Each command is listed in detail, as follows:
create link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide

LINK AGGREGATION COMMANDS

Parameter
group_id <value> {type [lacp | static]}
group_id <value>
group_id <value> ports <portlist>
{group_id <value>}
To create a link aggregation group on the Switch.
create link_aggregation group_id <value> {type [lacp | static]}
The create link_aggregation command creates a link aggregation
group with a unique identifier.
group_id <value> − Specifies the group ID. The group number
identifies each of the groups.
type – Specify the type of link aggregation used for the group. If the
type is not specified, the default type is static.
• lacp – This designates the port group as LACP compliant. LACP
allows dynamic adjustment to the aggregated port group. LACP
compliant ports may be further configured (see config lacp_ports).
LACP compliant must be connected to LACP compliant devices. The
maximum amount ports that can be configured in the same LACP
are 8.
• static – This designates the aggregated port group as static.
Static port groups cannot be changed as easily as LACP compliant
port groups, since both linked devices must be manually configured
if the configuration of the trunked group is changed. If static link
aggregation is used, be sure that both ends of the connection are
properly configured and that all ports have the same speed/duplex
settings. The maximum ports that can be configure in the same
static LAG are 8
Only administrator-level users can issue this command.
161
32