Voice Vlan Commands; Enable Voice_Vlan - D-Link DGS-1100-16/ME Reference Manual

The voice vlan commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable voice_vlan

disable voice_vlan
config voice_vlan
priority
config voice_vlan
aging_time
config voice_vlan oui
config voice_vlan ports
show voice_vlan global
show voice_vlan oui
show voice_vlan
voice_device
show surveillance_vlan
ports
Each command is listed in detail, as follows:
enable voice_vlan
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[ name <vlan_name 8> | vlanid <vlanid 1-4094>]
<0-7>
<min 1-65535>
[add | delete] mac <macaddr> mask <macmask> { description <desc 8> }
config voice_vlan ports [ list <portlist> | all] [ state [enable | disable] | mode
[autotagged | autountagged | manual]]
{ports <portlist>}
[list <portlist> | all]
Enables the global Voice VLAN function.
enable voice_vlan [ name <vlan_name 8> | vlanid <vlanid 1-4094>]
To enable the Voice VLAN function on a switch, the Voice VLAN
must be assigned a name and there must be an existing static
802.1Q VLAN.
To change the Voice VLAN parameters, the user must disable the
Voice VLAN function and then re-issue the enable command.
name <vlan_name 8> - The name of the voice VLAN
vlanid <vlanid 1-4094> - The VLAN ID of the voice VLAN.
Only administrator-level users can issue this command.

VOICE VLAN COMMANDS

151
30